1979 Electra Glide Shovelhead
#1
1979 Electra Glide Shovelhead
I recently bought a 1979 Electra Glide Shovelhead and the frame isn't equipped for a simple aftermarket seat. My bike is currently set up for a comfort flex seat or a simple solo seat, anyway I hate both of those seats.. The comfort flex seat sits me too high in the air and the solo seat is uncomfortable as hell. I was looking to purchase a Corbin seat however I don't know how to make it work to fit the bike. May I please get any advice from anyone on how to make it work?
The following users liked this post:
Pichilingo (11-24-2020)
#3
Join Date: Apr 2010
Location: Long Island, New York
Posts: 7,760
Received 4,935 Likes
on
2,569 Posts
#4
#5
Take the Pogo out and you can run aftermarket, actually I have a Lepera Bare Bones I used with the Frame inserts that you can buy from a hardware store. they are rubber with a threaded brass insert they go in each side of the frame in the through frame hole's. This is the setup I have and ran for years
Last edited by 72fl; 05-05-2018 at 07:09 AM.
#6
That is exactly right but I was told my hikb is so original and close to mint condition it would be a shame drilling a hole in it
#7
[edit:] I see by your other post you are trying to make the comfy seat work. Good idea!
Last edited by Joe12RK; 05-06-2018 at 08:45 PM.
Thread
Thread Starter
Forum
Replies
Last Post