some basic, basic questions and thoughts
#11
#12
I installed a ultima ignition that I thought was a zero dead rev ignition but it is not. The starter spins a couple times before it fires up. It starts great with the starter, runs great too, but at 3 revs it is difficult to kick and most of my kick attempts have failed. The kit included programmable ignition and coil and all wiring and like I said it runs great. It is important to me that i can kick it over pretty easily.
It kicked pretty easily and fired to life mid kick before but it did not run as smooth. Before it had electronic pickup with advance wieghts and a old cracked coil.
I would like to find a way to program the ultima to zero dead revs, the program kit that can do this is almost as much as the ignition so i am hoping i can find someone or a shop that has the program and can do it.
I have the same ignition on my ironhead and it is set to zero dead revs and the bike fires right up instantly. That bike is electric start only so i am thinking of just switching them but i am also lazy.
It kicked pretty easily and fired to life mid kick before but it did not run as smooth. Before it had electronic pickup with advance wieghts and a old cracked coil.
I would like to find a way to program the ultima to zero dead revs, the program kit that can do this is almost as much as the ignition so i am hoping i can find someone or a shop that has the program and can do it.
I have the same ignition on my ironhead and it is set to zero dead revs and the bike fires right up instantly. That bike is electric start only so i am thinking of just switching them but i am also lazy.
#13
#14
Thread
Thread Starter
Forum
Replies
Last Post
texasrpbrock
Dyna Glide Models
11
11-27-2016 02:55 PM