Installing Wild 1s 550s
#1
Installing Wild 1s 550s
I ordered new beach bars, risers and stainless steel line kit which includes throttle, idle, brake and clutch line. I was told that the factory wiring will work because there is some slack built into the harness. My concern is removing the pins from the 8 pin molex. I do not have a pin removal tool. Would it be easier to cut the harness, feed through the bars then solder and heat shrink the harness?
Any ideas/feedback would help. Thanks in advance!
L1
Any ideas/feedback would help. Thanks in advance!
L1
#2
Thread
Thread Starter
Forum
Replies
Last Post
HeritageTookMyMoney
Softail Models
15
03-17-2023 11:45 AM