I know this is an old thread but I'm hoping someone can steer me right on how to install the AA strut turn signals. I just got a pair for my '98 Dyna and upon inspection I don't see an easy way to conceal the wires.

It looks like the only way to keep the wires invisible will be to run them behind the chrome strut covers and I'm concerned if I do that, the wires will be pinched to the point of being cut. What am I missing?

Thanks much!

 

I cut a pretty big notch on the very end of my struts , since I had no plans to ever change it. I then ran the wires through the hole and back into the fender.
I did powdercoat the struts, and the Alloy Arts before the final install.
I like that they are almost unnoticeable until you turn them on, like the fronts.
Looks like photo upload problems, but a couple showed......

 

Thanks Gator......your bike looks great.

I'm hoping to not have to notch my strut covers but not sure there is any way around it if I go the AA route.