I just installed a set of 1 1/2" chrome spacers on my risers. That little bit of a spacer makes a difference. I like the drag bars but wanted them a little bit closer. Since they are a little up and back you aren't streching as much (I'm 6'2" so I didn't strectch to much anyway). Only thing I had to unhook was the Master Cylinder line from the frame. There was enough slack in all of the other cables.

 

Looks good.

 

Can I ask were you got your longer Riser Bolts? Must have went to around 4-4.5" or so?

 

Removed one of the stock ones and added the riser length to get the required length . Bought the bolts at Napa auto parts. That's what I did.

 

The bolts came with the spacers. Bought them on ebay and had the guy get the spacers chromed. Used my washers that were on the bike.

 

Where did you buy the spacers?

 

Got them from this guy. Read the whole add.
http://www.ebay.com/itm/Harley-David...item2c99fb30fa

 

Thank you

 

I installed my 1.5" spacers today and the wires are EXTREMELY tight, even after un doing the zip ties. I wonder why yours are longer. I need to find a solution, do they make plus n play extension of any kind, someone should make a wire kit that does that for Harleys as a lot of people do risers and apes.

 

My brake line has a little wiggle room locked to the left but is not tight. Everything else is fine. My spacers are 1.5". If I went 2" I would had to change the front brake line.