new member with questions
#1
#3
Not sure what the bells and whistles are but as far as the pipes go you can just put them on and ride away...
#4
#6
It may pop and bang a bit on decel because of the lean factory setup, but it won't do any real harm to anything.
You might want to get hold of the socket designed for the O2 sensor.
It works better than an open end wrench for pulling out the stock sensors, but isn't absolutely necessary.
If you put any anti-sieze on the threads, (always a good idea) just be careful to avoid getting any on or near the sensor end.
It can screw it up or make it fail completely if any of the stuff gets into it.
You might want to get hold of the socket designed for the O2 sensor.
It works better than an open end wrench for pulling out the stock sensors, but isn't absolutely necessary.
If you put any anti-sieze on the threads, (always a good idea) just be careful to avoid getting any on or near the sensor end.
It can screw it up or make it fail completely if any of the stuff gets into it.
Thread
Thread Starter
Forum
Replies
Last Post