Originally Posted by NSR

Nope, very similar but not H-D Rocker wheels. Look just a little closer. These have a smooooooth rim - no steps. "Soft Lip" is what I think they call it. The front wheel is 21x3.25, same as the original H-D BO wheel. The Rocker front wheel is smaller and narrower. Another difference is that the H-D BO wheel does not run on the bikes center line. It's not off-center by much, but it is. This new front wheel is centered - and it makes an amazing difference in how the bike handles. To finish it off, the wheel is fitted with a matching 5 Spoke brake rotor. It blends in so well you didn't even notice it, did ya? ....and it's bigger than the H-D BO rotor! A Performance Machine 6 piston caliper puts the squeeze on it.

The rear wheel is a little wider at 18x8.5". The Metz 260 fits perfectly. I didn't got for a matching 5 spoke rotor on the rear because I have something else in mind for the rear brake and rotor and for the primary and final drives. That'll get done this winter, hopefully. To make the wider rear wheel fit I did have to spring for a different pulley. It's been anodized completely black to try and keep it low profile.

I was looking for a set of very clean and simple wheels. These fit the bill. Got them from Rich at Bitchin' Seats. He's great to work with - knows his stuff and is a REAL perfectionist....no such thing as "good enough". It's either right or wrong and he will not settle for wrong.

Originally Posted by vtchopperdude

Heartland front fender finally painted and installed.

Originally Posted by rquest