Is there anybody that can just put a battery in my dynojet stack

 

 

its. The Original with the wenpep 7.? I've sent in 2 times for updates and its due for a battery

 

A replacement battery can be found on Amazon. Replacing the battery is easy. If you do it fast enough while the other battery is good. You might not loose filmware. If you remove battery and loose filmware. It has to go to dynojet because I don't know of any other place that can download the filmware. Here is a PDF

 

The PDF is a bit bigger than this forum will allow me to post. Send me your email and I will get it to you if you want it.

 

harleyfxdx@sbcglobal.net

 

There is no sending them back to dynojet after 01/01/2019 they do no more repairs now I'm going to get a battery and try it if I dont make it will just cost $2500 no big deal lol wish somebody had the firmware to be flasted

 

Talked to DJ at a show today. I brought up releasing the film ware. They laughed and said it wasn't going to happen, ever.

 

hrdtail78,

I have an old DynoJet 150 and would like to replace the battery in the hardware stack before it dies. I'd appreciate it if you could email the PDF file that you have for instructions on how to do it. I sent you an email.

 

when you remove the battery......before total disconnection at each terminal attach a jumper wire to a fully charged battery,, then remove from the battery you are replacing, keeping the jumpers in place, then re-attach new battery and remove jumpers. if done carefully, there should be no voltage loss and no firmware issues.
m