Combination speedo/tach swap and security system not working
#1
Combination speedo/tach swap and security system not working
Changed the speedo on a ‘20 Road King to the combo speedo/tach, was dead simple plug & play install. All seemed fine, until I noticed the bike started without the security fob nearby. Re-read the instructions a few times, and it states that the security light will flash for up to 15 seconds. Never saw that light flash, so I started testing a bit, turning the bike to Ign, Acc, etc. the red security light never came on, and the bike still starts without the fob present. After the 31.1 mile countdown, now the TC light remains illuminated, but the bike doesn’t have RDRS. Anyone else have this experience or tips? Dealership wasn’t much help unless I can leave the bike with them. This is literally a one-plug installation, couldn’t shank the install if I were dead-drunk... so what’s happening here?
Last edited by El_Supremo; 02-06-2021 at 04:24 PM.
#3
This is the second thread on this issue in the past couple of weeks. The OP in that thread never posted back with a solution.
PM him and ask if he found a solution or not.
PM him and ask if he found a solution or not.
#5
This is the second thread on this issue in the past couple of weeks. The OP in that thread never posted back with a solution.
PM him and ask if he found a solution or not.
PM him and ask if he found a solution or not.
Thread
Thread Starter
Forum
Replies
Last Post
BakerSierra
Electrical/Lighting/Alarm
0
02-28-2017 06:35 PM
bremsstrahlung
Dyna Glide Models
24
09-17-2012 12:06 PM
macmotor
Ignition/Tuner/ECM/Fuel Injection
0
05-31-2011 06:33 AM