Quick and dirty RK fairing storage bracket
#1
Quick and dirty RK fairing storage bracket
This is the good thing about having a Road King. I can ride with the windshield, with the fairing, or topless!
Going topless means having to leave the winshield and the fairing in the garage with the possibilities of getting all scratched out. So I made a wall mounting bracket out of two pieces of 2X6 screwed on to a piece of 1X6
The 2X6 are set exactly 11.5 in. apart on the outside, and the mounting points are some rubber bushings I found in the garage and some fender washers, the upper mount sits about 1 1/2 in. further towards the wall so that the fairing can mount straight up
close up of the mount
and my Dead Center
Now, If I go topless the winshield stays in a chair, and the fairing on the wall.
aaaahhhh..... peace of mind.
Regards,
Going topless means having to leave the winshield and the fairing in the garage with the possibilities of getting all scratched out. So I made a wall mounting bracket out of two pieces of 2X6 screwed on to a piece of 1X6
The 2X6 are set exactly 11.5 in. apart on the outside, and the mounting points are some rubber bushings I found in the garage and some fender washers, the upper mount sits about 1 1/2 in. further towards the wall so that the fairing can mount straight up
close up of the mount
and my Dead Center
Now, If I go topless the winshield stays in a chair, and the fairing on the wall.
aaaahhhh..... peace of mind.
Regards,
Last edited by TooEasy; 06-30-2010 at 07:56 AM.
#4
#6
#7
Trending Topics
#8
#9
Thread
Thread Starter
Forum
Replies
Last Post