Gas tank bolts
#1
Gas tank bolts
Just picked up a new to me 09 SG. I am going to be running some amp wires under the tank. It appears that the previous owner may have done some slight stripping of the front tank bolts when they ran wires for auxiliary lights. Given that I don't want to make this any worse, can someone tell me what size torx is supposed to be used on those front bolts for the gas tank? I want to make sure I get it right on the first shot.
Thanks everyone!
Thanks everyone!
#2
If those bolts are stock, they should be dual torx and standard 1/2” socket. If you want a cleaner look, try these.
https://colonyusa.com/products/harle...-chrome-2106-4
https://colonyusa.com/products/harle...-chrome-2106-4
#3
If those bolts are stock, they should be dual torx and standard 1/2” socket. If you want a cleaner look, try these.
https://colonyusa.com/products/harle...-chrome-2106-4
https://colonyusa.com/products/harle...-chrome-2106-4
#4
That means they can take a T40 or a 1/2" SAE socket.... you can use two different drives, dual use...
OEM bolt is part #3634, and uses either T40 torx drive or 1/2" SAE socket
If your torx portion has been messed up, use the 1/2" socket.... that is, if they are still OEM bolts...
Last edited by hattitude; 05-14-2019 at 09:41 AM.
#5
Ohhhhhhhh I gotcha. Ok that makes sense. I will look again. On the surface I want to say that they were rounded heads and not socket but I will check again when I get home.
Thread
Thread Starter
Forum
Replies
Last Post