Trailering tie-down points
#1
Trailering tie-down points
I picked up a dual Kendon standup trailer recently and am looking for some ideas on securing my Road King for a trip out west. I have 21" soft-strap extensions to go with the ratchet straps. I don't want to use the handlebar up front since this will surely damage the bushings.
My bike has a fairing and extended hard bags.
Thanks in advance
My bike has a fairing and extended hard bags.
Thanks in advance
#4
Join Date: Feb 2008
Location: Deep in the Piney Woods of East Texas
Posts: 3,202
Likes: 0
Received 4 Likes
on
4 Posts
Two soft ties round the frame at the top of the engine guard where it intersects with the frame. Then one each on the main floorboard support. Connect them to the main tie-downs and crank it down. I check the ties once in the first 45 minutes of travel and re-tighten if needed. Then I check em every time I stop for gas, etc. I have trailered my FLHX as far as North Carolina twice and it has never moved.
#5
Two soft ties round the frame at the top of the engine guard where it intersects with the frame. Then one each on the main floorboard support. Connect them to the main tie-downs and crank it down. I check the ties once in the first 45 minutes of travel and re-tighten if needed. Then I check em every time I stop for gas, etc. I have trailered my FLHX as far as North Carolina twice and it has never moved.
+1 on this, same here!!!
#6
#7
Going thru some old American Bagger rags (July2010) I saw this for the ones with trailer queens. They showed how to install it on a bat wing bike. It bolts on with the two gas tank bolts and the top engine guard bolt.
http://www.kiwi-indian.com/new-harley-prod.html
http://www.kiwi-indian.com/new-harley-prod.html
Trending Topics
#8
The rear passenger pegs are a great place to secure to. I use those, a WheelDock Chock up front, and a strap through the front wheel to the front tie down eyes. Both down tubes in the front just above the crash bar are also good.
#9
Use the bars - no damage will occur. I've towed many bikes many thousands of miles (racing) using the handle bars with zero negative effects. What will help is a brace you can pull the front of the bike down onto which will remove any suspension rebound from serious bumps or g-outs.
I made mine from three 2x6's, one on top of another (all about 8" long) with a piece of carpet on top. Put it underneath the forward part of the lower frame rails and pull the bike down onto it. You can then tie the rear of the bike down and it will never go anywhere.
I made mine from three 2x6's, one on top of another (all about 8" long) with a piece of carpet on top. Put it underneath the forward part of the lower frame rails and pull the bike down onto it. You can then tie the rear of the bike down and it will never go anywhere.
#10