Guys,
Sorry for what I'm sure is the billionth request for such info (I did do a quick search but wasn't able to find it) ...

My neighbor has a 2010 Street Glide with the 96 CI.
He asked me if I could help him do his oil (engine, tranny, primary) change.

He doesn't have the service manual, and the local Harley shop wouldn't provide the info ...

What I'm looking for is the following
Engine:
Capacity and Torque settings for the drain plug

Tranny:
Capacity and Torque settings for the drain plug and the "dip stick"

Primary:
Capacity and torque settings for the drain plug & derby cover.

I have a 13 Breakout with the 103. I'm thinking the torque values are probably the same (but want to verify), but expect the capacity is probably different.

Thanks for the help!

 

youtube LAB law abiding biker and they have a step by step that I find extremely helpful

 

Roger that ... will do.
I'm at work right now so my "searching capabilities" are some what limited :-D

 

I have a 2010SG

Primary, trans, and crank drain plugs 14-21 FT-LBS

Primary inspection cover 84-108 IN-LBS

Trans filler plug 25-75 IN-LBS

Capacities:

Primary 38 ozs
Trans. 32 ozs
Crank. 3.5 qts to start

 

MUCH appreciated!

 

DO NOT GO OVER THOSE TORQUE NUMBERS! I stripped my crank drain plug and I'm sure my torque wrench is close. The Harley mechanic told me they only go half the numbers because they have stripped a few plugs too. I now just go hand tight with blue loctite.

Beary

 

yea, I always go either to the smallest, or midpoint of range at most.
These are not that critical of components that need "maximum" torque.