For my SG, I changed out the headlight and went with the phase 7 Truck light.

At the suggestion of members, I changed the Headlight Bezel because the phase 7 sticks out a few inches further than the stock headlight.

I noticed that once the bezel is screwed around the headlight, although the screw and nut is secured, the headlamp trim ring is able to spin around.

Is this normal?

Thanks!

 

No. It should not move at all. Did you remove the stock trim ring? If it's the same as mine, it fits over the stock trim ring.

 

Oopsss. Thanks man. I now have it installed properly.

 

No problem. Make sure it's properly adjusted. Mine was pointing too far down after installation.