I'm writing on behalf of my brother-n-law who has a 14 TriGlide, he wants me to install a set of Khrome Werks 300519 2+2 narrow sweepers on his bike.

My question is for anyone who has installed these bars on a trike will he need any wire extensions or longer brake and clutch hoses

I installed the KW 300518 narrow +2 bars on my 17 CVO Limited and no additional hardware was needed

Thanks to everyone and ride safe

 

I put those bars on my 14 triglide. I also used the 2120-0368 wire ext. I didn't have to replace anything else.

 

Thanks for the info Arnie. No need for the reverse switch extension or throtle by wire extension?

 

'14, Same here.

Edit: Oh, I did solder in a 6" extension to the heated grips power lead, it just made it a lot easier to route. If he has heated grips.

 

that wire ext. is all I had to buy. I think I just rerouted everything else. It's been 4 yrs, so I don't remember all the specifics but I know that wire ext. is all I had to buy.

 

I used the wire extensions also; I could have done it without, but they made it easier. All the other hoses and lines have plenty of extra length wire tied under the fairing. I have the wide sweepers

 

Thank you gentleman for all the feedback. Gonna tackle the project this weekend and he does have the heated grips Oogie.