Can anybody ID these wheels from the 90's?
#1
Can anybody ID these wheels from the 90's?
PO said they were Performance Machine, some others have suggested CCI.
Anybody out there have a parts catalog from around 92-95 that might have them?
19" front, timken bearings, dual disc
16" rear, timken bearings
Came off a 92 FXRS Convertible
Mystery wheels
Anybody out there have a parts catalog from around 92-95 that might have them?
19" front, timken bearings, dual disc
16" rear, timken bearings
Came off a 92 FXRS Convertible
Mystery wheels
#3
I do beleive those where made by Sturgis? See here https://motoplaneparts.com/listing.php?pid=112457
#4
They should have "Sturgis" markings otherwise they could be copies made by another company? See here http://www.cas4.com/chrome_horse_whe...E%20WHEELS.htm
#5
#6
Since Performance Machine is a Sponsor here, and those wheels are claimed to be made by them, have you tried to contact them directly?
Maybe send a PM via this forum if nothing else?
Might be the easiest route, especially if they don’t read every post on every forum, every day.
.
The following users liked this post:
SWFLGuy (08-11-2019)
#7
Trending Topics
#8
#9
http://www.cas4.com/wheels-tires/whe...g-wheels2.html
Drag racers like them because they are a couple pounds lighter than a cast or billet wheel...and very strong.
I have a similar set that I have put on ebay, CL, and taken to swap meets without so much as a nibble.
If you notice mine has the 3 spoke swept rotor.
The following users liked this post:
Zach_the_gripper (08-11-2019)
#10
Actually revtech made those wheels in two different configurations forged two piece (which yours are) and billet...the forged were much cheaper...like half of what the billet cost.
http://www.cas4.com/wheels-tires/whe...g-wheels2.html
Drag racers like them because they are a couple pounds lighter than a cast or billet wheel...and very strong.
I have a similar set that I have put on ebay, CL, and taken to swap meets without so much as a nibble.
If you notice mine has the 3 spoke swept rotor.
http://www.cas4.com/wheels-tires/whe...g-wheels2.html
Drag racers like them because they are a couple pounds lighter than a cast or billet wheel...and very strong.
I have a similar set that I have put on ebay, CL, and taken to swap meets without so much as a nibble.
If you notice mine has the 3 spoke swept rotor.
The following users liked this post:
Mike Wood (03-14-2020)
Thread
Thread Starter
Forum
Replies
Last Post