I recently bought a Battery Tender Jr to use for my WG and the instructions tell you how to initially set up and connect the tender, but it doesn't say what is a safe way to disconnect it. Since it does not have a an on/off switch, I was wondering how everyone disconnects theirs? Do you leave the unit plugged into the wall all the time and connect/disconnect at the pigtail or unplug the pigtail, then unplug it from the wall and vice versa?

Thanks!
Navarre

 

Mine stays plugged in and connected till spring, but when i disconnect it, i unplug from the wall, then at the pigtail, but dont think it matters

 

I leave mine plugged into the wall all the time and just plug it into the plug on the bike when needed..

 

Mine stays plugged into a strip connector with an on/off switch. I turn it off before unplugging from the pigtail.

 

Unplug mine from wall before disconnecting from pigtail. Usually stays plugged in for several months over winter tho.

 

Shut off the breaker that goes to that plug. Then, make an appointment for a service call to have a certified H-D technician come to your house and do it for you.

 

Hooking up I plug in to the bike then the unit to power source (wall or power strip) Getting ready to ride I unplug the bike then unplug unit from the power source. Ride safe...

 

Lmao! I needed that today. Everything isn't rocket science!

 

Harley tech wouldn't do mine-it has to be a Harley tender. My neighbor is an electrician.I give him a few bucks to unplug it for me,and stay out of the garage while he does it.

 

Leave it plugged in to the wall, and plug/unplug to the bike as needed. Piece of cake.