Throttle by wire on 2014 Breakout?
#1
Throttle by wire on 2014 Breakout?
I'm looking to install the TBW system on my 2014 Breakout. As far as I can tell, I would need the handlebar sensor and an electronic controlled throttle body. There is a molex connector behind my air filter that is blanked off, assuming that is what would plug into the Electronic Throttle body from the ECU.
Besides that, new handlebars to accept the grip sensor and the cruise control assembly I think this is totally doable. It would clean my bars up a good bit and have a really nice cruise control system instead of that dingy throttle screw.
Any input on this is greatly appreciated!
Besides that, new handlebars to accept the grip sensor and the cruise control assembly I think this is totally doable. It would clean my bars up a good bit and have a really nice cruise control system instead of that dingy throttle screw.
Any input on this is greatly appreciated!
Last edited by UHDhog; 05-10-2016 at 01:14 PM.
#3
#7
Join Date: Aug 2008
Location: Lafayette, Louisiana
Posts: 21,758
Received 14,178 Likes
on
6,218 Posts
Trending Topics
#9