Blinker Trim rings
#1
01-27-2008, 06:52 PM
Join Date: Nov 2007
Location: bristol, ct
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
Blinker Trim rings
Hi All
This is my first post i just picked upa 05 Deluxe. I bought a set of the smoked lens trim rings for the front and rear blinkers. I can't seem to get them too fit, it seems like the tabs on the new ring don't go in far enough to reach the groove in the blinker housing. Dealer says they are the right ones. Anyone else ever have this problem?
Thanks
Bill
This is my first post i just picked upa 05 Deluxe. I bought a set of the smoked lens trim rings for the front and rear blinkers. I can't seem to get them too fit, it seems like the tabs on the new ring don't go in far enough to reach the groove in the blinker housing. Dealer says they are the right ones. Anyone else ever have this problem?
Thanks
Bill
#2
01-27-2008, 07:41 PM
Cruiser
Join Date: Sep 2006
Location: Alabama
Posts: 163
Likes: 0
Received 0 Likes
on
0 Posts
RE: Blinker Trim rings
If I'm understanding your question, make sure you're following the installation instructions - if you're trying to push the trim ring on by the edges, it won't lock in place. I believe the instructions say to lock it in place by pressing on the center of the lense - it makes a difference. Then, I think it will lock in place. At least that was my experience when I was installing them without reading the instructions first. 
#3
01-27-2008, 07:52 PM
RE: Blinker Trim rings
ORIGINAL: Legalcarry
If I'm understanding your question, make sure you're following the installation instructions - if you're trying to push the trim ring on by the edges, it won't lock in place. I believe the instructions say to lock it in place by pressing on the center of the lense - it makes a difference. Then, I think it will lock in place. At least that was my experience when I was installing them without reading the instructions first.
If I'm understanding your question, make sure you're following the installation instructions - if you're trying to push the trim ring on by the edges, it won't lock in place. I believe the instructions say to lock it in place by pressing on the center of the lense - it makes a difference. Then, I think it will lock in place. At least that was my experience when I was installing them without reading the instructions first.
Thread
Thread Starter
Forum
Replies
Last Post
Cloud09King
Touring Models
35
03-10-2009 10:23 AM
