dtc codes problems
#1
dtc codes problems
I have an 09 Ultra that has recently had some work done, some by me and some at the dealer. Installed the boom amp, oil temp gauge, and custom aulilliary light kit for the passing lamps. I did this while the wheels were off for tires. I decided to replace the wheel bearings and the indy with the tires put the wrong L F bearing in (I have ABS) and I didn't know why the front pads were dragging and ended up sending the bike to the nearby dealer. So they fixed the bearings but have slightly warped rotors they said, but said I could handle that later down the line. Today I go about 60 miles one way, not noticing anything odd but on the way back after about a couple hour break, the ABS light comes on, not flashing, and the volts drop to about 8 along the way. Codes say, first P PO 132, second P PO 52, then none, none, none and the last one, I guess its a b says CO 562. Can't find the b code listed anywhere so am wondering if someone can help.
Thanks
put this on the dyi side but haven't seen a reply
Thanks
put this on the dyi side but haven't seen a reply
#2
PO132 means Front Cylinder running Rich. Can't find PO52, Maybe it's PO152 Which means Rear Cylinder Running Rich. CO562, device running low, a low voltage condition prevents the ABS from operating properly. Hope this Helps. Try to find the cause of the voltage drop, fixing it may solve all Your problems.
Last edited by Dionicio; 09-25-2011 at 05:12 PM.
Thread
Thread Starter
Forum
Replies
Last Post