Need to figure out the 135_off equivalent but with the fader active.

 

Correct.... Fader does not work with 135_OFF.

 

Maan... For me it's just so friggin quiet with 135_OFF/ON.bin.

also my bass is turned up to darn near max (with 00_OFF/ON.bin it was the other way so it didn't distort when turned up loud)

Sadness...

 

I'm waiting for someone to confirm, but I think the CVO Limiteds are flashed with the 135_OFF.bin from the factory. That would make sense as they use can us to control the fader. It would also mean that nothing really magical is done (beyond canbus) when a Boom amp is added vs an aftermarket amp.

 

So----135_off.bin isn't working for everyone and with that we lose fader control?

Doesn't sound like a solution yet. Hopefully the OP is going to continue to research.

 

For me it's fine.... I only use the 2 front channels to run my system... no fader needed. If you use all front and rear outputs. ... then that would be an issue..agreed

 

So you are saying that this solution is limited to SG's with aftermarket amp and only two speakers?

 

Went to three different dealerships to look at the bin files, and they are all 14_OFF/ON.Bin for the CVO limited. It is 15_OFF/ON.BIN for the Road Glide Limited.

Couldn't find a CVO street glide anywhere

 

No... all I am saying is that with my setup (maybe others ) I use the front 2 Channel outputs to run my 600.4 and 4 speakers from 4 Channels on my amp.... fader in the radio would do nothing for me since I only use the two front outputs.

 

There is a 15 CVO Street Glide at my dealer.... if I make it down there... I will check it and post up...