Amp setting with BT355 LL
#1
Amp setting with BT355 LL
Hello,
I know the topic of adjusting line levelers has been brought up a lot but wondering if i can get some help regarding gain on the amp.
I have a soundigital evo 800.4s amp and using the BT355 with break out harness for front/rear amp output. According to the amps instructions for setting gain, i disconnect all speakers and run a 60hz wave through the radio at 3/4 volume and measure output voltage at each channel. The target voltage it wants me to get is 20 volts AC. The issue here is even with the amp gain all the way up, the max voltage i can get is around 16 volts AC. I backed the gain off to about 6.5 volts and that put me about 45% on the gain. Listening to the music play, it is clear and i can not pick up any distortion at all. Amp puts out 110 rms per chanel and all my speakers are rated well above that.
This leads me to my question. Should I adjust the gain on the line levelers and then readjust my amp voltage? I am thinking the line leveler gain is restricting the voltage input and wondering if it is making the amp work to hard. Any help from you gurus would be much appreciated.
I know the topic of adjusting line levelers has been brought up a lot but wondering if i can get some help regarding gain on the amp.
I have a soundigital evo 800.4s amp and using the BT355 with break out harness for front/rear amp output. According to the amps instructions for setting gain, i disconnect all speakers and run a 60hz wave through the radio at 3/4 volume and measure output voltage at each channel. The target voltage it wants me to get is 20 volts AC. The issue here is even with the amp gain all the way up, the max voltage i can get is around 16 volts AC. I backed the gain off to about 6.5 volts and that put me about 45% on the gain. Listening to the music play, it is clear and i can not pick up any distortion at all. Amp puts out 110 rms per chanel and all my speakers are rated well above that.
This leads me to my question. Should I adjust the gain on the line levelers and then readjust my amp voltage? I am thinking the line leveler gain is restricting the voltage input and wondering if it is making the amp work to hard. Any help from you gurus would be much appreciated.
#5
#6
Originally Posted by Toner123
Because thats what the soundigital instruction manual said to use and i am a noob lol. When i called biketronics and told them this, she never mentioned 100hz cut. She mentioned 40hz.
T
#7
Trending Topics
#8
#9
Did you buy all equipment from one place or did you piece together? Just thinking you might be a little light on power for that setup.
#10
i am not looking to enter sound competitions. Just need something i can hear clearly while cruising since i wear ear plugs. The system sounds way better then my boom 2 setup that was previously in the bike.
Last edited by Toner123; 06-24-2020 at 10:58 AM.
Thread
Thread Starter
Forum
Replies
Last Post