Wiring help seres or parrellel ?
 

Trying to understand all this before I blow something and I think I may have wired wrong already, current set up is stock head unit on a 2009 street glide pac loc stinger amp mmats 601 cx how should this be wired ? As I believe stock head unit is 2 ohm ? Right now I have it wired to front channels positive speakers to positive on amp , negative speakers to negative amp
thank you for any and all help

You have it wired correctly. As far as the ohm rating on the HU, that's a non issue once you have an amp in place.

Thank you I appreciate it
I think too much reading can make a newbie such as myself second guess everything

Sounds right. If you are only using the 2 speakers, you should have channels 3&4 not being used.

Will be adding 2 mores speakers tomorrow to the tour pack wire them the same way on the other 2
channels ?

Also if I use the multimeter and test tone to set the gains how do I figure out what number I’m looking for ? I’ve looked at the chart but still not sure I understand
it, speakers are 601 cx front prv 6 mb 250 rear

Set them by ear.

Technically....

We don't have enough information....IMO..

The fronts come in 4 or 8 ohm.

The stinger 700?

The Only way to sufficiently power the rears is in 3 channel mode with them wired in parallel to the 350x1 at 4 ohm. Otherwise they will be severely underpowered.

Amp is
175W at 2ohms.
125 at 4 ohms.
Should be(but no ratings) 75 at 8 ohms which is just enough for your fronts if they are 8 ohm.

Sorce

Stinger spx 700 x 4 front speakers are mmats 601 cx 4 ohm rear speakers will be prv 6 mb 250 4 ohm

You will want to wire that in stereo, 1 amp channel per speaker. No series or parallel.