2010 Dyna Question
 

I have a 2010 wide glide and I'm getting ready to install my V&H big radious pipes. Does anyone have the torque numbers for the 4 header bolts? Sorry my service manual is on order i just haven't recieved it yet.

My research says 100-110 INCH LBS.

Greg

Thanks! You wouldn't happen to know if there is a torque number for the o2 sensors or just hand tight?

According to the 07 Manual:


Tighten flange nuts (35), at front cylinder studs as follows:
a. Install lower nut and tighten finger tight.
b. Install upper nut and tighten to 9-18 in-lbs (1-2 Nm).
c. Tighten lower nut to 60-80 in-lbs (6.8-9.0 Nm).
d. Tighten upper nut to 60-80 in-lbs (6.8-9.0 Nm).

8. Tighten flange nuts at rear cylinder studs as follows:
a. Install upper nut and tighten finger tight.
b. Install lower nut and tighten to 9-18 in-lbs (1-2 Nm).
c. Tighten upper nut to 60-80 in-lbs (6.8-9.0 Nm).
d. Tighten lower nut to 60-80 in-lbs (6.8-9.0 Nm).

Thanks!!!!

I don't see anything for the O2 sensors. Gee, why would anyone need that? Nobody would ever use anything but stock pipes right? LOL