Dyna Glide ModelsSuper Glide, Super Glide Sport, Super Glide Custom, Dyna Glide Convertible, Super Glide T-Sport, Dyna Glide Police, Dyna Switchback, Low Rider, Street Bob, Fat Bob and Wide Glide.
This guy does all kinds of nice stuff. Mainly Derby plates, but recently started with cowbells as well...if you want to keep it but a different design.
Have to agree - gone looks better than modified. Put Honda.............ahem, Blackline horn between the top down tubes, sounds like crapola but I never use it anyway.
This looks great. Where'd you get the little hanger for the plug wire? Can you post some details on the relocate?
Originally Posted by AeroMike
Your wire holder fastener looks like a titanium collar hucked on there. Looks nice and clean. Did you make the wire holder yourself?
I used home electrical wire (Romex wire). I pre-formed it on a bolts shank that was the same size as the ignition wire, then opened up the loops and wrapped it around the ignition wire.
Originally Posted by WS6 Formula
You can also make your own, for the front cylinder support put a tie wrap on the ignition lead than insert the pig tail of the tie wrap through the hole in the top cylinder bracket, use another tie wrap head to secure it on the other side of the bracket like I did below on my clutch cable. The rear support you can use part of a large tie wrap, poke two holes through it with a soldering iron, and use two small tie wraps to tie the leads together.
Originally Posted by WS6 Formula
Last edited by WS6 Formula; 11-16-2011 at 08:55 PM.