Hello, 2015 Dyna Street Bob, looking to get rid of my stock turn signals and switch to the Rivera Primo Phase2 headlight. I know when you switch to LED turn signals you need a load equalizer and I was looking at the BT-801 from Biketronics.

The question I have is on the website it only list 2001-13 Dynas, will this still work on a 2015? Does anyone know if the wire harness is the same as the 2001-13s?

Equalizer:
http://www.biketronics.com/bt-801-smart-equalizer/

Thanks!

 

Found the answer. After 2013 the CAN electrical system is used and you don't need a load equalizer.

 

When you switch over your indicator on the dash may blink fast but your signals will blink fine. I think you can fix that fast blink rate by running your hazards for about 5 minutes