15 Year Member
Liked
Loved
Top Answer: 5

98hotrodfatboy

Seasoned HDF Member

About Me

  • About 98hotrodfatboy
    Biography
    Been ridin most of life.
    Location
    Poolville
    Interests
    Touring,Fishing,Snowmobiling
    Occupation
    Steam Fitter
    Country of Residence
    US
    Gender
    Male
  • Signature
    98 FLSTF Fatboy, 97" stroker, Super G, Baker 6 spd, Hillside Stage III heads, Woods W8 cam...
    2013 FXDBP, 117", Woods 9F, Hillside stage IV heads, PV Tuner, HPI 62 mm,. Both bikes are a shit load of fun...

Statistics

Total Posts
Albums
Visitor Messages
Total Likes
General Information
  • Last Activity: Today 07:52 PM
  • Join Date: Mar 11, 2010
  • Referrals: 0

Friends

Showing Friends 1 to 10 of 12

Visitor Messages

Showing Visitor Messages 1 to 7 of 7
  1. johnjzjz
    Jun 2, 2023 06:33 PM
    Hey some are trying to convince spomini shovel rat to repair his cases with a leaking race not the seal
  2. BrianM
    Feb 10, 2020 07:07 AM
    Thank you very much for the link. I'll follow it up at work tomorrow.

    Much appreciated.

    Brian.
  3. johnjzjz
    Sep 8, 2018 09:57 PM
    when the carb needs to be real fat to run - the VE is very low - and it takes forever to rev out

    so 100 HP at the tire in 2 minuets on a dyno in 4 th gear will be out run by a bike that make 70HP if it spins the dyno in one minuet

    most only have numbers not substance
  4. glidein wide
    Jul 17, 2018 06:51 PM
    Yo Bob,remembered you wanted the date for Killingly bike night..thursday August 16 only from 5-9 pm. Rain date is on the 22 nd ,Wednesday. Long ride for a short event for you.
  5. aces&8s
    Jul 18, 2017 07:53 PM
    Hey Hotrod, I installed the new 1" taller S&S air filter. Before I installed it my spark plugs were slightly rich or darker gray color. I have not rechecked my plug color yet and was wondering when you went to the larger filter did it lean your bike out? Thanks
  6. aces&8s
    Jul 11, 2017 03:36 PM
    Hows the new build doing? Have not heard from ya lately and just checking on you.
  7. The old guy
    Dec 8, 2015 05:55 PM
    hello I'm thinking of using Teflon [good to 500deg.]for cam and rocker shims ?

All times are GMT -5. The time now is 09:27 PM.