Night Train Night Mare
i picked up a kit to put a sissy bar on my 2000 night train and figured id bang it on there no problem. I now see that getting the existing hard out is a chore the only way i see getting the bolts out would be to take the tire off. Any help on this would be great.
|
RE: Night Train Night Mare
Have you tried jaking it up where the tire is off the ground? I was able to do it with my 06, but maybe youre is different.
|
RE: Night Train Night Mare
ill try that i was thinking that may work
|
RE: Night Train Night Mare
Just remove your seat, remove the 2 screws holding the ECU, and move it out of the way. Reach into the fender from there with a 9/16" wrench to hold the 2 nuts on each side while you loosen/tighten the Torx bolts, and you're done. Much easier than taking half the darn bike apart.
|
RE: Night Train Night Mare
the back star bolts just turn and turn and there is nothing on the otherside i can see to hold on to I am gonna have to take this sucker in and get it done i think its impossible.
|
RE: Night Train Night Mare
While your at the dealer, buy or order a service manual. It will pay for itself in the long run.
|
RE: Night Train Night Mare
The rear-most bolt has no separate nut- it's part of the fender. Those will simply unscrew. The next two forward bolts have nuts behind them (inside the fender). The two most forward bolts also have no separate nuts- they screw into the actual framehorn. The nuts are 9/16".
Keep in mind, the dealer will probably charge at least one hour's labor for 15 minutes' work. |
RE: Night Train Night Mare
are these nuts possibley locktited in i cant get them to budge
 \\; |
RE: Night Train Night Mare
Yea they got some serious something on them. \\; I think they are size 45 torx. \\; The 40 fits but will not give you the grip you need or will strip it out. \\; You need a long handle wrench to get the leverage to need to pop them loose.
|
All times are GMT -5. The time now is 01:38 PM. |
© 2024 MH Sub I, LLC dba Internet Brands