polishing aluminum lower forks
#1
#2
I've done it all by hand in my garage for my last 3 bikes.
I remove the fender and wheel and install the axle to keep the fork tubes aligned.
Dry sand starting with 200 grit, 300, then 400, then wet sand with 600 and 800.
from there I wet sand with #1, #0, #000 steel wool dipped in Flitz metal polish.
Very happy with the results.
Takes a solid day to do both legs. But once they are done, it is very easy to maintain. When the bike gets cleaned, I just run over the legs with Flitz and the #000 steel wool and it really makes them gleam.
I remove the fender and wheel and install the axle to keep the fork tubes aligned.
Dry sand starting with 200 grit, 300, then 400, then wet sand with 600 and 800.
from there I wet sand with #1, #0, #000 steel wool dipped in Flitz metal polish.
Very happy with the results.
Takes a solid day to do both legs. But once they are done, it is very easy to maintain. When the bike gets cleaned, I just run over the legs with Flitz and the #000 steel wool and it really makes them gleam.
#3
#4
Here is how I have done the last couple of bikes I have had. Remove fender, strip clearcoat off with a chemical paint stripper, wet sand starting with 400 grit, 600grit, 800 grit and finish sanding with 1500 grit. You can do this by hand but on areas not so tight I cheated and used a palm sander with a spray bottle. Then I attached a 4" sewn polishing wheel to my drill using a long bolt and some washers and buffed it using Flitz metal polish. And afterwards just touch up every three months or so with either aluminum tool box polish, Flitz or Brasso. Takes about 5 hours from taking off the fender to riding. Absolutely no regrets, get some beer turn on some tunes and get started!
#5
sanded wet with 800, 1200, 2000, ultra fine, then mothers power cone or ball on power drill ( cordless didn't work as well...not enough speed/heat) using aluminium polish then regular polish.....result: not chrome but vast improvement & looks like it from 15 foot away, don't rush it, each step done well makes for a better finish.
#7
Trending Topics
#10