What did you do to Your Softail Today?
#5681
The following users liked this post:
Johnny Goodlife (06-23-2017)
#5683
I've been looking at seats and I checked out the ultimate. Any other seats you recommend besides the ultimate that would also lose an inch or two?
#5686
#5687
No, Corbin is another sit on top.
I have a Corbin and an Ultimate for my Lo. The Corbin wins in finish quality. The Ultimate smokes it in comfortability and sitting down in the bike. Ultimate is about 2" lower in the bike.
Corbin are pretty and will keep you from getting a numb *** but that's all that can be said for them.
I have a Corbin and an Ultimate for my Lo. The Corbin wins in finish quality. The Ultimate smokes it in comfortability and sitting down in the bike. Ultimate is about 2" lower in the bike.
Corbin are pretty and will keep you from getting a numb *** but that's all that can be said for them.
Last edited by TeaRunner; 06-22-2017 at 07:42 PM.
#5688
It's lower than stock and you can request even lower. There is nothing 'sit on' about it. They are very well sculpted.
Comfort wise simply amazing.
This is a pic of a standard (non-custom dual tour) Corbin. I have a custom on the way. It will be lower, firmer, more square at the seat back (less curved transition to vertical at the back of the ***) and it will have less hump at the front before the tank between the legs.
Comfort wise simply amazing.
This is a pic of a standard (non-custom dual tour) Corbin. I have a custom on the way. It will be lower, firmer, more square at the seat back (less curved transition to vertical at the back of the ***) and it will have less hump at the front before the tank between the legs.
The following users liked this post:
Ceez (06-22-2017)
#5689
#5690
Thank you CeeZ, I appreciate that.
It's a Ginz Choppers, back pad as well. The bar is about 29 inches measured from the fender and the pad is 13 inches tall. If I was doing it again I might want the pad a little shorter.
Here it is from the rear.
It's a Ginz Choppers, back pad as well. The bar is about 29 inches measured from the fender and the pad is 13 inches tall. If I was doing it again I might want the pad a little shorter.
Here it is from the rear.
The following users liked this post:
Ceez (06-23-2017)