Deluxe License Plate Relocation?
#11
Last edited by kozy22; 04-17-2014 at 09:37 PM.
#13
Really?? What part of...
"I bought the cheapest lighted license plate frame I could find and ran the wiring into the brake light housing. I grounded the ground on one of the bolts inside the housing and ran the positive wire to the tail light bulb itself. I just wedged the exposed wire in between the bulb and the receptacle."
...was hard to understand?
Last edited by yzergod; 04-18-2014 at 05:37 PM.
#16
#17
This one is super low profile. Works well with the Softbrake plate bracket.
http://www.customdynamics.com/illumi...0Plate_Frames_
http://www.customdynamics.com/illumi...0Plate_Frames_
#20
How did you guys splice the new plate mount led wires in. Did you cut the existing plate bulb wire and splice the run wire to that? I don't have a bolt inside the housing for the ground. The tail light wires are grounded with a rivet so I don't wanna screw with that.
I see someone jammed it in the bulb socket. Guess that's an option. I figured I'd cut it off and remove the existing bulb and use that wire and splice it in with a posi-tap. Not sure what to do with ground.
I see someone jammed it in the bulb socket. Guess that's an option. I figured I'd cut it off and remove the existing bulb and use that wire and splice it in with a posi-tap. Not sure what to do with ground.
Thread
Thread Starter
Forum
Replies
Last Post