post pics of your sporty bobber
#104
Hi ... that's a really nice bike but I would be worried about that rear fender almost sitting on the tire ... I hope it's not rubbing/pinching any of your electrical wires ...
Last edited by kingxirol; 04-30-2015 at 10:26 PM.
#105
Thanks. There are no wires underneath the fender anymore. I mad sure to give it enough room for tire growth at highway speeds. I've been 200 miles on the chop so far and everything on the rear is ok. I did have the front axle nut fall off though.....
#107
They do not seal, but I dont need them to because
I use MSR fuel canisters to contain the fuel, these are
only the "holders". A bit of laquer thinner takes off the
yellow print. They work great. Here's some pics at a
different angle.
hope this helps,
T.
#109
Join Date: Nov 2010
Location: Red Banks, Mississippi
Posts: 17,479
Received 3,962 Likes
on
2,309 Posts
Pic of the latest evo on the Project 48. Was out for a little putt today.
__________________
Kevin
Gear Up & Ride in! DK Custom 4th Annual Open House, June 8th. 🏍️ Click HERE For The Lowdown.
DKCustomProducts.com
Kevin
Gear Up & Ride in! DK Custom 4th Annual Open House, June 8th. 🏍️ Click HERE For The Lowdown.
DKCustomProducts.com
#110
Man, sdf's 72 is clean as hell, here is mine. Contemplating ape hangers, but might just trade it in and get a 72..
Would like to get a 7" light up front
This bike would look muck better w spokes, imho
Drilled into my bag to mount my license plate. I thought it was creative enough to post, ha
Would like to get a 7" light up front
This bike would look muck better w spokes, imho
Drilled into my bag to mount my license plate. I thought it was creative enough to post, ha