Burly brand apes and heated grips?
#1
Burly brand apes and heated grips?
Looking at getting a set of the 13" burly brand bagger apes and wire/cable kit. they have a small disclaimer at the bottom of the page that says they might not work with some heated grips but didn't specify which ones. I'm using the stock heated grips that came on the (2010) FLHTK. I emailed burly but haven't heard back yet. I'm hping to get the kit soon so i can dig in and get it over with before spring.
anyone running these with the heated grips? if not can you suggest any 12"-14" bars in the sub $300 range that will work?
anyone running these with the heated grips? if not can you suggest any 12"-14" bars in the sub $300 range that will work?
#3
#4
I also have 10" Wild Ones with HD heated grips (non-stock). I notched the rubber flange on the left grip to run ALL the wires internally. I did have to cut about 3/8" off the left bar to allow the trip and master cylinder to slide all the way to the step up in the bars. There is a link to my bike below with lots of pictures of the install toward the end.
The following users liked this post:
electra_boogaloo (02-23-2017)
#5
#6
Originally Posted by electra_boogaloo
Good point. I'm getting a cable kit but I'm 110% sure they don't account for heated grips
http://www.guerrillacables.com/Ultim...%20Bagger.html
The following users liked this post:
electra_boogaloo (02-23-2017)
#8
Thanks for the info. I haven't been inside the bars yet so i'm still fuzzy about how the heated grips connect. how difficult of a job was the bushing removal/install? did you need any special tools?
#9
#10