'17 King Dash Panel Issue
 

Left turn and High Beam indicator out. Right turn and neutral indicator working.

What should I look for?

Failed light bulbs in dash ?

That's the first thought I had but I'm not familiar with the arrangement or best way to access. I've had the dash loose to run a fixed USB cable but haven't completely disconnected and looked at the construction.

The Rushmore bikes are canbus so you have input from the switch to the BCM and output to the indicator lights from the BCM. Just a guess but I'd say the indicator lights are LED. Are the lights working and just the indicators out?

Turn signal (front and rear) as well as headlight (high and low) are totally functional.

Thank you for the input.

Confirmed the "lights' are not servicable
they are integrated into the block on harness # 69200124

Thank you.

This "Parts Finder". Is it a download or dealership exclusive?

Just type in " Ronnies Parts finder"

Thanks for your help eighteight

Finally got around to ordering the replacement harness last week. Picked it up this afternoon and installed. Quick and easy plug n play but it didn’t work as expected. Dash display had nothing. The neutral indicator was illuminated even with the switch off. The turn indicators didn’t work as well as no high beam indicator. Removed and put the old one back in and it works just like before.

Dunno how it could be but did I do something wrong?

Bad design of the instrument indicators RK2017
 

https://cimg6.ibsrv.net/gimg/www.hdf...655bb61e8.jpeg
https://cimg7.ibsrv.net/gimg/www.hdf...471888bec.jpeg

the problem is that the plastic housing is eroding and punches a hole between R9 and C4 in the electronic board of the indicators, cutting the circuit to the High Beam and Left turn signal LEDs on the dash. I slightly removed the blue paint to expose and soldered connecting back the copper circuit to fix the issue.

Even if you buy a new one if it has the same design I have no doubts it will fail again due to vibrations. Blue dust is visible on the plastic housing where it touches the board.

I’ll place some form of thin insulator over that area to prevent another erosion of the PCB. And keep €120 for beer.