Fishafly, I’m going to go with a 21” front with single disc. Are you running a 13”rotor? How do you block off the right side break line? Did you change your lower legs to get rid of the right side bracket?

 

21 x 3.5 and 18 x 4.25 Here also

 

I tried to pull the trigger on a set of wheels on Firday but no responce. Anybudy had any experience with MC Motorsports?I like the look of their black and chrom Reapers.

 

The width is measured inside the rim from bead to bead. Stock is 16 x 3.0. Most after market 16's are 3.50". Give us a call. We got rims! 818-886-6545

Jerry @ Hogpro

 

Sent you a PM, let me know what you can swing.

 

mopar...
I'm runnin an 11.5 inch rotor from Renegade to match my Phoenix wheel... With the PM 6 piston I have no problems at all... Not sure if Renegade makes a 13" or not... I did change the lower leg, although I know alot of guys who use chrome bolts to plug the holes.. MUCH less expensive if not quite as clean... If you go single you'll need to change your master cylinder to a 9/16 bore, which I did then I just ran a single line to the caliper... just like on a softie.. Hope this helps..

 

21 x 3 1/2 in front & 16 x 3 1/2 with a 90h/21 avonvenem in the front & stock dunlop in back

 

That looks good, but i don't think my arms are long enough to ride that Bad ****!

 

I will 2nd Jerry over at HOGPRO. They are awesome to deal with. Their products rock, and service/knowledge are the best. A+++ I went with their 18" Black Magics front and rear. Metz 880's

 

[sm=roll.gif][sm=smiley4.gif]thanks