Advice for those that have not done the hinge upgrade yet
#11
#12
#13
Another nuggett from Dawg!
Gret tip Dawg!
I won't be up tosee you till later this year, ...knee replacement surgery end of March. I hope to riding by mid May at least. I'll be up by then. Still working the parts dept in Lebanon?
If you get a chance stop by the 4Aces and say "hey" to the girls there for me, especially Nellie!
I won't be up tosee you till later this year, ...knee replacement surgery end of March. I hope to riding by mid May at least. I'll be up by then. Still working the parts dept in Lebanon?
If you get a chance stop by the 4Aces and say "hey" to the girls there for me, especially Nellie!
#14
Gret tip Dawg!
I won't be up tosee you till later this year, ...knee replacement surgery end of March. I hope to riding by mid May at least. I'll be up by then. Still working the parts dept in Lebanon?
If you get a chance stop by the 4Aces and say "hey" to the girls there for me, especially Nellie!
I won't be up tosee you till later this year, ...knee replacement surgery end of March. I hope to riding by mid May at least. I'll be up by then. Still working the parts dept in Lebanon?
If you get a chance stop by the 4Aces and say "hey" to the girls there for me, especially Nellie!
#16
Thanks for the part number, dawg.
Here is the link: http://www.harley-davidson.com/gma/g...bmLocale=en_US
After 30,000 miles the only thing on my Ultra the vibrated loose was the screws holding on the hinges. A little blue thread loc fixed that, but those new hinges do look nice!
Here is the link: http://www.harley-davidson.com/gma/g...bmLocale=en_US
After 30,000 miles the only thing on my Ultra the vibrated loose was the screws holding on the hinges. A little blue thread loc fixed that, but those new hinges do look nice!
Last edited by MNPGRider; 03-07-2009 at 03:02 PM.
#17
Well, I'm ordering a new Tour Pack, I mighty as well get the new hinges too and install them while the tour pack is loose.
I gotta say that DAWG has been tremendously helpful to me in getting the right bill of material to do this job which is something like 10 parts now and costing roughly $1625 all total.
Dawg helps to make this Forum a great success and he desreves allot of thanks and credit. Good job DAWG!
I gotta say that DAWG has been tremendously helpful to me in getting the right bill of material to do this job which is something like 10 parts now and costing roughly $1625 all total.
Dawg helps to make this Forum a great success and he desreves allot of thanks and credit. Good job DAWG!
#20
Yeah Dawg ,,,,another good tip there,,,also remeber that the pins under the gasket are real tough to get to straight on and take your time ,,,,,, i almost had a new hole there ! drill slipped off the rivet and into the plastic in the lid ,,,pulled back in time ,,,but that was TOO close.........but man those hinges look good !!!!