What did you do to your bagger today?
I picked up a take off road glide ultra windshields from an 18 for 10 bucks. Will work on my standard until I have the spare funds for a freedom shield like I've used in the past.
I started this project in December and finally completed it today:
Installation of an audio system with handlebar speakers & bluetooth controller, a handlebar mounted USB charger, a 12v lighter plug tucked away under the seat, a RAM mount system for my cell phone and a new battery.....Woo hoo! Can't wait for riding season
Installation of an audio system with handlebar speakers & bluetooth controller, a handlebar mounted USB charger, a 12v lighter plug tucked away under the seat, a RAM mount system for my cell phone and a new battery.....Woo hoo! Can't wait for riding season
I'm looking to create a similar custom seat but I did not see this configuration - which Mustang seat is this one? Thanks!
Got the rear wheel installed tonight after work. It was a bear to get the axle lined up with the abs sensor and caliper bracket workimg by myself but finally got it done. If the weather is decent tomorrow I will clean it up and go for a ride, maybe get a pic with a rear wheel that isn’t dull compared to the front.
That is the ‘Tripper fastback’ 75646. I had them put the alcantara material in the center. It is a suede like material, double diamond with white stitching. I had to email them, and ask them specifically for that style. Nicest seat I’ve ever seen. They hit it out of the part.
The following 2 users liked this post by Schmidt0221:
ad3333 (02-22-2019),
no1martian (03-01-2019)
That is the ‘Tripper fastback’ 75646. I had them put the alcantara material in the center. It is a suede like material, double diamond with white stitching. I had to email them, and ask them specifically for that style. Nicest seat I’ve ever seen. They hit it out of the part.
Installed LED's in my tour pack
I installed Custom Dynamics LED kit in my tour pack this afternoon. Actual work time to install was 30 minutes. I had to wait 6hrs for the epoxy to dry though.
It was a straight forward project that was really easy. Use a hair dryer or heat gun to heat up the sealant around the taillight covers and pop them out. Remove the old bulbs. Push the LED panels into place and epoxy them in. Let dry for 4-6hrs. Heat up the lens sealant again and push the lenses back into place. Couldn't have been much easier.
It was a straight forward project that was really easy. Use a hair dryer or heat gun to heat up the sealant around the taillight covers and pop them out. Remove the old bulbs. Push the LED panels into place and epoxy them in. Let dry for 4-6hrs. Heat up the lens sealant again and push the lenses back into place. Couldn't have been much easier.
Just did about a 50 mile ride after having the JNR air ride kit installed, once you find the sweet spot between height and comfort it really put the bike where I want it, fun on the fly too with the handlebar mounted switch, next I have a set of Advanblack bags and fender extension waiting to go on, I'll post pics after that's done.