What did you do to your bagger today?
Wilburbill thanks for the response. I'm using 1/4hose myself. Figured out how thin the backing plate is. Going to go with the hose between the cylinder and push rod tubes also. I did get some supposedly heat resistant hose so I guess we both will see what works.
The following users liked this post:
wilburbill (12-28-2022)
Buell95
Does that long finned cooler get in the way when you remove the rear wheel?
Diesel X
I used soft aluminum 1/4" tubing. Just clean with acetone, and wipe it down with alumiblack and no one will see it. Its small enough OD to fit between the cylinder fins for easier routing. For areas that need it, 1/4" oil resistant rubber hose, held on with pinch clamps.
Does that long finned cooler get in the way when you remove the rear wheel?
Diesel X
I used soft aluminum 1/4" tubing. Just clean with acetone, and wipe it down with alumiblack and no one will see it. Its small enough OD to fit between the cylinder fins for easier routing. For areas that need it, 1/4" oil resistant rubber hose, held on with pinch clamps.
Buell95
Does that long finned cooler get in the way when you remove the rear wheel?
Diesel X
I used soft aluminum 1/4" tubing. Just clean with acetone, and wipe it down with alumiblack and no one will see it. Its small enough OD to fit between the cylinder fins for easier routing. For areas that need it, 1/4" oil resistant rubber hose, held on with pinch clamps.
Does that long finned cooler get in the way when you remove the rear wheel?
Diesel X
I used soft aluminum 1/4" tubing. Just clean with acetone, and wipe it down with alumiblack and no one will see it. Its small enough OD to fit between the cylinder fins for easier routing. For areas that need it, 1/4" oil resistant rubber hose, held on with pinch clamps.
and dropping it down.
You’d have to remove it in case you need to get access to main fuse, right ?
The following users liked this post:
Medevack1 (12-27-2022)
may I ask what batwing fearing this is and what gps/ car play unit you added , how the speakers sound ? It’s something I’m dreaming about down the road
The following users liked this post:
binarym (12-28-2022)
Last edited by Medevack1; 12-27-2022 at 10:51 PM.
The following users liked this post:
Bhrees (12-28-2022)
Got my DK Customs Thunder Torque inserts. I'm off the rest of the week so I plan to put them in as well as finish my Dayton dsp install, 1275N clutch springs and finned spark plug covers. Once I get the springs and exhaust inserts installed, I can make an appointment at Fuel Moto to get the bike tuned..