what is the maxx CCP
#1
what is the maxx CCP
what is the maxx cold cranking pressure i can run ?
live in alabama and i almost always have access to 93 octane . im looking at a 103 bb for my 07 electraglide along with a andrews 54h cam .
im trying to figure out what my maxx compression i can run without compression releases ?
also what is the maxx compression i can run with a good tune without pinging IF i get compression releases?
live in alabama and i almost always have access to 93 octane . im looking at a 103 bb for my 07 electraglide along with a andrews 54h cam .
im trying to figure out what my maxx compression i can run without compression releases ?
also what is the maxx compression i can run with a good tune without pinging IF i get compression releases?
#3
#4
the tune, altiude and fuel quality all play a part here!
you could run close to 220 with relases and a tight tune. but 200 is the ceiling for the most part.
alot of guys prefere the 180 area so they dont have to downshift as much, they can just roll on the throttle in high gear and not get much pining.
you could run close to 220 with relases and a tight tune. but 200 is the ceiling for the most part.
alot of guys prefere the 180 area so they dont have to downshift as much, they can just roll on the throttle in high gear and not get much pining.
#5
Cranking Compression Ratio
We set most at 190-195.
On occasion, if the bike gets geared, (3.37 or more) then you can lean on it more, as it won't load the engine.
On occasion, if the bike gets geared, (3.37 or more) then you can lean on it more, as it won't load the engine.
__________________
HILLSIDE MOTORCYCLE & MACHINE, INC.
HARLEY-DAVIDSON SPEED & SERVICE CENTER
5225 SOUTH MAIN ST., MUNNSVILLE, N.Y. 13409
Sales/Support 315-495-6650
www.hillsidecycle.com
Walk-in Retail Showroom
Complete H-D Machine Shop
Case & cylinder boring
Complete Cylinder Head Shop
High-Performance Engine Kits
Crank Rebuilding
Direct Link & PowerVision Tuning
Goodson HD Tooling Manufacturer
Maxton Mile World Record
4500 sq ft. facility
OVER 35 YEARS OF H-D ENGINE BUILDING.
See us on Facebook.
HILLSIDE MOTORCYCLE & MACHINE, INC.
HARLEY-DAVIDSON SPEED & SERVICE CENTER
5225 SOUTH MAIN ST., MUNNSVILLE, N.Y. 13409
Sales/Support 315-495-6650
www.hillsidecycle.com
Walk-in Retail Showroom
Complete H-D Machine Shop
Case & cylinder boring
Complete Cylinder Head Shop
High-Performance Engine Kits
Crank Rebuilding
Direct Link & PowerVision Tuning
Goodson HD Tooling Manufacturer
Maxton Mile World Record
4500 sq ft. facility
OVER 35 YEARS OF H-D ENGINE BUILDING.
See us on Facebook.
Trending Topics
#8
It runs good, Sunday I was able to put 30 miles on it. It has been pretty cold out. I won't be having it Dynoed until April. I want to put at least 500 miles on it first. It felt pretty strong but the Dyno will tell. According to the calc on Big Boyz, yes it is around 10.2-1
The compression releases help it start a lot easier, it also is going to be something to remember now. Have to get in the habit of using them.
The compression releases help it start a lot easier, it also is going to be something to remember now. Have to get in the habit of using them.
Thread
Thread Starter
Forum
Replies
Last Post
cts1950
Ignition/Tuner/ECM/Fuel Injection
2
11-28-2008 07:50 AM