Front Fender Rubber Grommet Replacement
#1
Front Fender Rubber Grommet Replacement
What is the easiest way to replace the rubber grommet in the front fender of an FLHTC? This is the one that protects the electrical wire to the front fender lamp.
#2
The wires plug up in the fairing and most times you can get to them with out pulling the fairing off or at least I can on my 02 ultra. Just fallow the wires. Now the problem is the connectors will not fit through the hole in the fender. So I would just cut the wires a couple inches down from the connectors them pull the wires through the hole in the fender replace the rubber bushing then after putting the wires back through the rubber bushing butt splice the wires and put heat shrink over the but splices. My rubber bushing has been missing for about 60,000 miles with out a problem.
#3
The wires plug up in the fairing and most times you can get to them with out pulling the fairing off or at least I can on my 02 ultra. Just fallow the wires. Now the problem is the connectors will not fit through the hole in the fender. So I would just cut the wires a couple inches down from the connectors them pull the wires through the hole in the fender replace the rubber bushing then after putting the wires back through the rubber bushing butt splice the wires and put heat shrink over the but splices. My rubber bushing has been missing for about 60,000 miles with out a problem.
Thread
Thread Starter
Forum
Replies
Last Post