grind tab for new pegs or what?
#1
grind tab for new pegs or what?
Installing my new pegs and I notice that there is some little stop tabs that are preventing the peg from fully folding back. They stay where they are fine but just don't fold all the way back like they should. I can either reshape the peg to go around the tab or grind off the tab in the peg mount. What has anyone done? I usually ride with rear pegs up unless I have a passenger.
tab
max able to be folded in
view from inside
contact point
tab
max able to be folded in
view from inside
contact point
Last edited by slyedog; 05-29-2015 at 11:46 AM.
#3
I talked to figure machine. They are going to machine some new swivels to the piece that I milled down. They didn't look right nor want to stay up without excessive force on the bolt to where I could hardly move them. These tabs either aren't that common or no one cares how their pegs sit?
#6
#7
Trending Topics
#8
#10
You are Loopie. Look closer. Stare at it a while. Allow yourself to be consumed by it. The exhaust port has a grey spot right before the flame leaves the pipe on both cylinders.
Last edited by slyedog; 05-30-2015 at 01:39 AM.