im looking to put mid controls on got a oe set but can someone tell me how to get #4 out so i can install #27??

 

also if i buy mounts 31 and 32 will they bolt right in place of the ones i have on my bike with the forward controls on them??

 

You have to take off the sprocket cover to get to the nut that holds #4 in place. and yes 31 and 32 can replace the oem parts that have the forward controls on them. I swapped out my mids for stock forwards a couple years back. I like the forwards better.

 

MrCookie is correct. There is a nut on the back of the sprocket cover that holds that bolt in place.

 

ya know we were thinking that but thought "there is no way this peg is just held onto the cover" looks like we should have went for the gut shot lol
thanks guys i appreciate it
im keeping all my forward parts if i decide i dont like the mids, but my short *** legs and coming from sportbike world i feel i will like them, plus i rode a buddies that had mids and like it so we shall see!!

thanks again!!!!!

 

Not trying to hijack your thread but the diagram you have is a great reference for me. I just changed from kids to forward controls on my wife's 2002. The rear brake pivot is still incorporated in the forward control setup and I was wondering how to eliminate the footpeg mount? Looks like part 27 in the first diagram can be replaced with part 4 but how?

 

Stupid spell check! Mids not kids!

 

as stated above, ( i havnt done it yet) you need to remove the sprocket cover and you will find a nut on the back side, order that bolt and nut to re install and your good to go.

while here on your wifes bike did you change the front motor mounts?? if so want to sell the old ones???

 

well i got all the parts and peices and it all went together nice, ride is so much more comfy for me too with my short legs

 

Here is a pic seeing I'm not allowed to upload more then one pic at a time from my phone...