Well I literally just got back from my Indie where they finished up on tuning my bike. They installed Andrews 57 cams, SE Tapered PR's, GMR Lifters, Fuel- Moto X pipe and tuned with the Power Vision along with 4" RC Mufflers.
I can't say enough for these guys, J&B Performance. Anyway heres the sheet, hope it's big enough to read !
Last edited by Tn.Heritage; 08-08-2014 at 12:39 PM.
I am having a hard time reading the numbers in the picture. Does it say 100 HP with the new parts? Pretty nice if so!
It does say 100.78hp, sorry about the picture. Took with cell. I do also think the cost is well worth it to gain 24hp and 23tq. I think that's about a 25% increase. Almost 1hp per cube.
What was your highway miles-per-gallon before the modification?
What's your highway miles-per-gallon after the modification?
I'm still going through the break-in procedure for less than 500 miles, & am getting high 39s.
Thank you!
RThomas, that is not a stupid question but to be honest I never really put a pin on it but it seemed like I was getting around 40mpg. Sadly I haven't got to pick up the bike cause of rain. It was late when the guys finished the dyno runs so I didn't get her home yet, hopefully tomorrow evening.
My mileage should be better though, I was getting 41mpg with my 106" motor so I figure this will do a little better than that.