Thanks Alan I did look at your 30T install thread, I got my tool list from it, great thread good info... I couldn't remember if you replaced the bearing/race. The baker website says the high torque bearing fits up to 07. Is there another option for the later dynas? I need to remove the bearing for PC anyway...

 

Congrats !!!! Should be a blast!!

I'm slowly gathering parts for a 117" build....

 

kirby is a top guy he knows what he doing

 

Shipped out the lower end, heads and some other parts today. Let's hope everything makes it to Florida in one piece



Got me fingers crossed

 

I would have liked to have seen how you packed those pieces up (especially the lower end), what did you use to brace it?

 

Yea I'm sorry man I should have taken some pictures before I sealed it up. I put the lower end in a thick plastic bag, vacuumed the air out and zip tied and taped it. I went to Home Depot and bought a big sheet of 1" styrofoam insulation. I lined a smaller box with it and put the motor in there with a bunch of bubble wrap. Then I shrink wrapped that entire box. Then I double lined the allied box in the styrofoam and put the smaller box in it. It's packed tight as hell. Then when I went to the ups store they made me buy one of their boxes so I could insure it. So the damn thing is in 3 boxes haha, Kirby's going to have fun getting it out

 

That sounds real good, sounds like it will hold up well.

Can't wait for you to get your hands back on these parts!

 

I got a question for you guys running d&d, and Bassani exhausts. Do any of these 2-1 pipes use the stock exhaust bracket that is under the cam cover? I was finally able to get that damn thing off and I'm going to leave it off if none of the other 2-1 pipes use it. I don't think any of them do but I'd like to double check

 

The Bobcat does not use it.

 

Yes, the D&D Fat Cat uses that bracket.