So I just got some parts back from being powder coated and I think I have a problem but not 100% sure yet. So this is what I see, the center part "bezel"? Doesnt seem to fit flush in the front. Im not really sure if it did before or not. Does it normally fit snug on the front? Only thing I can think of is that the heat way of warped it. Its a 2012 WG btw

Thanks
Rodney

 

The center part bezel of what, the dash, headlight, speedo.? A picture would help a lot.

 

Sorry what I mean is the front part of the bezel past the speedo where it rolls over the tank near the bars. mine doesnt sit flat on the tank. I'll try to take a pic tomorrow.