Pushrods on 1980 Shovelhead
#1
Pushrods on 1980 Shovelhead
So I was replacing my pushrods and hydraulic lifters on 80 Shovelhead. I got to the 0 heel put the lifter and rod in. Started adjusting the rod but I think I may have over tighten it because I could only get wheel to go to a certain point. And now I can't get the rod out again (stuck on the bottom,0 ) not sure if I bent the rod either since I can't get it out to look at it. Anyone know what I could do to get that sucker back out again?
Last edited by Dragonlady; 04-24-2017 at 03:31 PM.
#2
What does the service manual say?
Scott
Scott
__________________
HILLSIDE MOTORCYCLE & MACHINE, INC.
HARLEY-DAVIDSON SPEED & SERVICE CENTER
5225 SOUTH MAIN ST., MUNNSVILLE, N.Y. 13409
Sales/Support 315-495-6650
www.hillsidecycle.com
Walk-in Retail Showroom
Complete H-D Machine Shop
Case & cylinder boring
Complete Cylinder Head Shop
High-Performance Engine Kits
Crank Rebuilding
Direct Link & PowerVision Tuning
Goodson HD Tooling Manufacturer
Maxton Mile World Record
4500 sq ft. facility
OVER 35 YEARS OF H-D ENGINE BUILDING.
See us on Facebook.
HILLSIDE MOTORCYCLE & MACHINE, INC.
HARLEY-DAVIDSON SPEED & SERVICE CENTER
5225 SOUTH MAIN ST., MUNNSVILLE, N.Y. 13409
Sales/Support 315-495-6650
www.hillsidecycle.com
Walk-in Retail Showroom
Complete H-D Machine Shop
Case & cylinder boring
Complete Cylinder Head Shop
High-Performance Engine Kits
Crank Rebuilding
Direct Link & PowerVision Tuning
Goodson HD Tooling Manufacturer
Maxton Mile World Record
4500 sq ft. facility
OVER 35 YEARS OF H-D ENGINE BUILDING.
See us on Facebook.
Thread
Thread Starter
Forum
Replies
Last Post