New pipes and high idle?
#1
New pipes and high idle?
Hoping you guys can point me in the right direction on this. I recently replaced my stock exhaust with Samson true duals on my 94 Heritage, and it seems like my idle RPM is quite a bit higher than before. The pipes are 33", baffled, no other perf mods other than air cleaner. The bike has a stock Keihin CV carb.
Are the new pipes likely the cause, and if so do I need to replace my slow jet? Or is it simply a matter of adjusting the idle? Is this better for a real wrench to tackle rather than a mechanically challenged newbie like myself? I'm pretty sure I can handle the re-jetting if necessary, but don't have any diagnostic equip or even a multimeter to check revs. Wondering also if timing becomes an issue.
Thanks for any knowledge you can pass along.
Are the new pipes likely the cause, and if so do I need to replace my slow jet? Or is it simply a matter of adjusting the idle? Is this better for a real wrench to tackle rather than a mechanically challenged newbie like myself? I'm pretty sure I can handle the re-jetting if necessary, but don't have any diagnostic equip or even a multimeter to check revs. Wondering also if timing becomes an issue.
Thanks for any knowledge you can pass along.
#2
#3
#4
From messing around with tuning EFI systems, the idle will raise if it leans out some, more fuel will load the engine and slow down.
Turning your air/fuel screw will tell you if you need a low speed jet change and should be able to get the idle back with that adjustment, if you go too close to being seated or to far out and not right, you need a low speed jet change but as members have mentioned, a stock low speed jet is versitle.
Hopefully a member can break the air/fuel screw down a little bit more because I can't remember which way is which and don't want to put out some bad info, everytime I put something new into my head, something else leaves
By the way, love the Silver/White Heritage
Turning your air/fuel screw will tell you if you need a low speed jet change and should be able to get the idle back with that adjustment, if you go too close to being seated or to far out and not right, you need a low speed jet change but as members have mentioned, a stock low speed jet is versitle.
Hopefully a member can break the air/fuel screw down a little bit more because I can't remember which way is which and don't want to put out some bad info, everytime I put something new into my head, something else leaves
By the way, love the Silver/White Heritage
Last edited by 1997bagger; 03-31-2011 at 10:46 AM.
#5
#6
#7
Thanks a lot guys. I'm tempted to swing it by a shop but I'm going to pull the carb so I can get that idle mixture plug out and see if I can play with it a bit. From what I've read, right is leaner left is richer. I'll try to do it by ear and hope I can get close to 1000 rpm.
Trending Topics
#10
I would do as said above and back off the idle adjustment till she sounds right. If you have to change jets later, most bikes can be done with the carb on the bike. I just drop the bowl off and it's an easy job. My 99 carb already had the idle mixture scew drilled out when I got it. I had a stock 42 slow jet in mine, and changed it to a 45. Main jet was already updated from a 75 to an 80. Mine had a K&N air filter, and drag pipes.