Thanks for the help on my Andrews EV27 cam swap
#1
Thanks for the help on my Andrews EV27 cam swap
Just wanted to say thanks to all the people that replied to my post's on Andrews EV27 cam swap questions that I had. "Great info" . The cam went in yesterday. I installed an Andrews EV27 cam ,new torrington bearing, adj pushrods, a .055 cam shim and oil seal (no lifters because the motor only has 9000 miles on it). The cam end play was set at .013 (Andrews says .010-.015) so all good there. Cant fire it up till next week because I have to get the Tappet block alignment pins. So thanks again for the info.
Thread
Thread Starter
Forum
Replies
Last Post