Street Rod Handlebar Change
#21
#22
Street Rod XG750a changing Handle bar
My boyfriend and I are trying to put 7/8 mini apes on my 750 street rod and haven’t found a lot of information on wether we will need to get a custom cable for it or not? Was there more slack under the tank? Is there any sites you would recommend that would help with installing these bars?
Cheers
#24
#25
I picked up a Biltwell "Tracker" bar (7/8", lowest one) to change out early on, wanting just a little more height.
Looks like there's enough slack in everything to go up a little, if you don't get carried away with the height.
Main stumble for me were the locating holes that would have to be drilled (reasonably accurately) for mounting the controls. The two little clips for the cables could be replaced with tie wraps, but the locating pins for the controls will need their respective holes in place for proper and secure mounting.
You'd need to get the bar rotation set just right and make sure you're happy with it before you start drilling, or the controls aren't going to be in the right position.
It is, unfortunately, not just a simple "unbolt and swap" modification...
Looks like there's enough slack in everything to go up a little, if you don't get carried away with the height.
Main stumble for me were the locating holes that would have to be drilled (reasonably accurately) for mounting the controls. The two little clips for the cables could be replaced with tie wraps, but the locating pins for the controls will need their respective holes in place for proper and secure mounting.
You'd need to get the bar rotation set just right and make sure you're happy with it before you start drilling, or the controls aren't going to be in the right position.
It is, unfortunately, not just a simple "unbolt and swap" modification...
Thread
Thread Starter
Forum
Replies
Last Post