Dave0176
Thread Starter
Classic / EVO Today 11:34 AM
Jackie Paper
Did someone uses it as a emergency brake or the last owner weight 500 lbs.
Somethink is obviously bent or the stand is a replacement not designed for that bike.
touchdown
Thread Starter
Harley Davidson Motorcycles / General Harley Davidson Chat Today 11:22 AM
What's up with that. But you can always count on Jackie Paper and Rounders to have an answer.
Softail Models / 2018+ Softail Models Today 11:16 AM
Put 4 QTS in run the piss out of it, change at 5K and do over again over and over again until trade-in time.
Harley Davidson Tech & Mechanical Forum / General Topics/Tech Tips Today 11:15 AM
Where is Stuart Smalley when we need him?
John
handirifle
Thread Starter
Harley Davidson Motorcycles / Sportster Models Today 11:15 AM
Yea I guess I have to see what those are. Thanks. Never tried that conversion before.
Touring Models / 2024+ Center-Cooled Touring Models Today 11:10 AM
20W 50 works for me
NM Pan-shovel
Thread Starter
Classic / Ironhead Today 11:03 AM
Question: is it possible to pull the engine from an Ironhead without R&Ring the heads? On some bikes, you can do this, on others, you cannot.
Thanks!
Harley Davidson Motorcycles / Dyna Glide Models Today 10:55 AM
I installed one of those Predator mounts on the FXDL some years back and it is IMO a much improved one over the factory mount.
guarddan
Thread Starter
Harley Davidson Classifieds / Want To Buy Motorcycles/Parts/Accessories Today 10:55 AM
I am looking to buy the part number 94000937 touring model service manual if someone has one that they didn't happen to use and wants to sell. Thank you.
Harley Davidson Tech & Mechanical Forum / Engine Mechanical Topics Today 10:47 AM
Good job. Nice to have it corrected.
I knew it had to be a vent issue. No engine should hold vacuum after shut down over a few seconds.
I was asked to help on an issue with a TPE 331 Turbo Prop...